☀️ Energy Experience
See where every watt comes from · visitor display
→
🔧 Generator DiagnosisStep 3 of 3
Is there an Alarm or Warning Light on the Generator Panel?
The generator alarm panel sits next to the start button on the engine room bulkhead. Active faults show as red LED indicators or an error code (E-XX) on the small LCD. Note the code and any accompanying text — WMC needs both to dispatch the correct part or schedule a service visit. The current ECU error is E-04 (overspeed cut-out).
AYes, there is an Alarm on the PanelBNo Alarm — Panel appears NormalCI cannot Access the Generator PanelBattery
0%
State of Charge
F
N
A
SoC
0
%
POWER
--
kW
Solar
0
W
24V Battery
--
kW
SOG
--
kts
Voltage
24.1
V
Current
0.0
A
Power
0.0
W
Mode
IDLE
Recommendation
⚠️ Generator was scheduled to auto-start when battery dropped to 30%. It cranked once and the ECU reported E-04 (overspeed cut-out) — auto-start aborted. Battery continues to drain under house load. Fuel supply is available.
Reason: Motor motor Motor fault
System HealthCRITICAL
5%
⚠ Critical system offline — navigation systems unavailable | Battery critically low at 0% — connect shore power or reduce loads immediately | 1 deep discharge event(s) recorded — battery health degraded (12pt penalty) | Vessel power lost — OKi running on backup battery
OKi Care
Care Score
25%
